Airspace, Weather Minimums and Charts, Part 107 certification 2025

« Go to categories

1. (Refer to Figure 26.) What does the line of latitude at area 4 measure?
2. (Refer to Figure 21.) What airport is located approximately 47 (degrees) 40 (minutes) N latitude and 101 (degrees) 26 (minutes) W longitude?
3. (Refer to Figure 20, area 2.) Why would the small flag at Lake Drummond of the sectional chart be important to a remote pilot?
4. (Refer to Figure 20, area 3.) With ATC authorization, you are operating your small unmanned aircraft approximately 4 SM southeast of Elizabeth City Regional Airport (ECG). What hazard is indicated to be in that area?
5. (Refer to Figure 23, area 3.) What is the floor of the Savannah Class C airspace at the shelf area (outer circle)?
6. According to 14 CFR part 107 the remote pilot in command (PIC) of a small unmanned aircraft planning to operate within Class C airspace
7. (Refer to Figure 26, area 4.) You have been hired to inspect the tower under construction at 46.9N and 98.6W, near Jamestown Regional (JMS). What must you receive prior to flying your unmanned aircraft in this area?
8. According to 14 CFR part 107, how may a remote pilot operate an unmanned aircraft in class C airspace?
9. (Refer to Figure 21.) You have been hired by a farmer to use your small UA to inspect his crops. The area that you are to survey is in the Devil's Lake West MOA, east of area 2. How would you find out if the MOA is active?
10. (Refer to Figure 59, area 2.) The chart shows a gray line with "VR1667, VR1617, VR1638, and VR1668." Could this area present a hazard to the operations of a small UA?
11. (Refer to Figure 20, area 5.) How would a remote PIC "CHECK NOTAMS" as noted in the CAUTION box regarding the unmarked balloon?
12. Under what condition, if any, may you operate an unmanned aircraft in a restricted area?
13. Flight through a restricted area should not be accomplished unless the remote pilot has
14. What action should a remote pilot take when operating in a Military Operations Area (MOA)?
15. The width of a Federal Airway from either side of the centerline is
16. Unless otherwise specified, Federal Airways include that Class E airspace extending upward from
17. A blue segmented circle on a Sectional Chart depicts which class airspace?
18. (Refer to Figure 20, area 3.) Determine the approximate latitude and longitude of Currituck County Airport.
19. (Refer to Figure 21, area 2.) Which airport is located at approximately 47°34'30"N latitude and 100°44'00"W longitude?
20. (Refer to Figure 21, area 3.) Which airport is located at approximately 47°21'N latitude and 101°01'W longitude?
21. (Refer to Figure 22, area 3.) Determine the approximate latitude and longitude of Shoshone County Airport.
22. (Refer to Figure 26, area 2.) What is the approximate latitude and longitude of Cooperstown Airport?
23. (Refer to Figure 25, area 4.) The floor of Class B airspace overlying Hicks Airport (T67) north-northwest of Fort Worth Meacham Field is
24. (Refer to Figure 25, area 2.) The floor of Class B airspace at Air Park-Dallas Airport is
25. (Refer to Figure 20 area 4.) What hazards to aircraft may exist in restricted areas such as R-5302B?
26. (Refer to Figure 21, area 3.) What type military flight operations should a pilot expect along IR 644?
27. (Refer to Figure 26, area 3.) When flying over Arrowwood National Wildlife Refuge, a pilot should fly no lower than
28. (Refer to Figure 24, area 1.) For information about the parachute jumping at Caddo Mills Airport, refer to
29. (Refer to Figure 26, area 1.) Identify the airspace over Tomlinson Airport (8J7).
30. (Refer to Figure 26, area 5.) The airspace overlying and within 5 miles of Barnes County Airport is
31. (Refer to Figure 25, area 7.) The airspace overlying McKinney (TKI) is controlled from the surface to
32. (Refer to Figure 25, area 4.) The airspace directly overlying Fort Worth Meacham is
33. (Refer to Figure 22, area 3.) The vertical limits of that portion of Class E airspace designated as a Federal Airway over Magee Airport are
34. (Refer to Figure 20, area 5.) The CAUTION box denotes what hazard to aircraft?
35. (Refer to Figure 20, area 2.) The flag symbol at Lake Drummond represents a
36. (Refer to Figure 20, area 2.) The elevation of the Chesapeake Regional Airport is
37. (Refer to Figure 21.) The terrain elevation of the light tan area between Minot (area 1) and Audubon Lake (area 2) varies from
38. (Refer to Figure 23.) The flag symbols at Statesboro Bulloch County Airport, Claxton-Evans County Airport, and Ridgeland Airport are
39. (Refer to Figure 23, area 3.) What is the height of the lighted obstacle approximately 6 nautical miles southwest of Savannah International?
40. (Refer to Figure 23, area 3.) The top of the group obstruction approximately 11 nautical miles from the Savannah VORTAC on the 007° radial is
41. (Refer to Figure 25, area 2.) The control tower frequency for Addison Airport is
42. The vertical limit of Class C airspace above the primary airport is normally
43. The normal radius of the procedural Outer Area of Class C airspace is normally
44. Responsibility for collision avoidance in an alert area rests with
45. The lateral dimensions of Class D airspace are based on
46. Pilots flying over a national wildlife refuge are requested to fly no lower than
47. One of the purposes for issuing a Temporary Flight restriction (TFR) is to
48. Which is true concerning the blue and magenta colors used to depict airports on Sectional Aeronautical Charts?
49. With certain exceptions, Class E airspace extends upward from either 700 feet or 1,200 feet AGL to, but does not include,
50. Information concerning parachute jumping sites may be found in the
51. Which statement about longitude and latitude is true?
52. (Refer to Figure 20, area 1.) The NALF Fentress (NFE) Airport is in what type of airspace?
53. The purpose of Military Training Routes, charted as VFR Military Training Routes (VR) and IFR Military Training Routes (IR) on sectional charts, is to ensure the greatest practical level of safety for all flight operations and to allow the military to conduct
54. Under which conditions may a pilot fly under VFR within 60 nautical miles of the DCA VOR in Washington, D.C.?
55. The airspace system designations used throughout the United States
56. Uncontrolled airspace is
57. What is the maximum allowable groundspeed for a UAV beneath Class B airspace?
58. (Refer to Figure 78.) You have been hired to use your small UAS to inspect the railroad tracks from Blencoe (SE of Sioux City) to Onawa. Will ATC authorization be required?
59. (Refer to Figure 25, area 3.) The floor of Class B airspace at Dallas Executive (RBD) is
60. (Refer to Figure 78.) What class of airspace is associated with SIOUX GATEWAY/COL DAY (SUX) Airport?
61. (Refer to Figure 75, area 6.) During preflight planning, you plan to operate in R-2305. Where would you find additional information regarding this airspace?
62. (Refer to Figure 21, area 1.) After receiving authorization from ATC to operate a small UA near Minot International airport (MOT) while the control tower is operational, which radio communication frequency could be used to monitor manned aircraft and ATC communications?
63. (Refer to Figure 24, area 6.) What type of airport is Card Airport?
64. (Refer to Figure 20, area 4.) A small UA is being launched 2 NM northeast of the town of Hertford. What is the height of the highest obstacle?
65. (Refer to Figure 24, area 3.) For information about the parachute operations at Tri-County Airport, refer to
66. (Refer to Figure 78.) You have been contracted to inspect towers located approximately 4NM southwest of the Sioux Gateway (SUX) airport operating an unmanned aircraft. What is the maximum altitude above ground level (AGL) that you are authorized to operate over the top of the towers?
67. The VFR pilot flying in Class G airspace
68. You know when looking at a chart that the floor of Class E airspace is 700 feet AGL when it's within